Install the Windows Server VPN Role Server 2016

July 2019 (0) Iptv 5/3/2024

This post shows you how you can install a VPN Server on Windows Server 2016 Step-by-Step. It shows you how you can easily setup a VPN server for a small environment or for a hosted server scenario. This blog post covers how you can use Windows Server VPN.

This is definitely not a guide for an enterprise deployment, if you are thinking about a enterprise deployment you should definitely have a look at Direct Access.

I already did similar blog posts for Windows Server 2008 R2, Windows Server 2012 and Windows Server 2016.

HOW TO INSTALL VPN ON WINDOWS SERVER 2016

Install the Windows Server VPN Role

First install the “Remote Access” via Server Manager or Windows PowerShell.

Select the “DirectAccess and VPN (RAS)” role services and click next.

On the next steps just use the default settings. After that you can have a look at the overview screen and install the role.

After the features are installed, which can take a while to finish you see the link for the Getting Started Wizard. Click on “Open the Getting Started Wizard“.

Configure Windows Server VPN

This opens a new wizard which will help you to configure the server. On the first screen select “Deploy VPN only“.

This opens the Routing and Remote Access Management Console

Right click on the Server name and click on “Configure and Enable Routing and Remote Access“.

On the new wizard select “Custom configuration“.

Select “VPN Access“.

After you have click finish you can now start the Routing and Remote Access service.

If you have an other firewall between the internet and your Windows Server you have to open the following Firewall port sand forward them to your Windows Server:

For PPTP: 1723 TCP and Protocol 47 GRE (also known as PPTP Pass-through)
For L2TP over IPSEC: 1701 TCP and 500 UDP
For SSTP: 443 TCP

After the installation Users have to be enabled for Remote Access to connect to your VPN Server. On a standalone server this can be done in the Computer Management MMC, in a domain environment this can be done in the user properties of an Active Directory user.

If you don’t have a DHCP Server in your environment you have to add a static IP address pool. This is often needed if you have a single server hosted at a service provider. In the properties of your VPN server you can click on the IPv4 tab and enable and configure the “Static address pool”.

You now have to add a IP address from the same subnet as your static address pool to the network interface of your server, so users can access the server.

I hope this helps you to setup a VPN server in a small environment, lab or hosted server.

Yorum yapabilmek için giriş yapınız

Giriş Yap